Power & Operations

The new standard ANSI/ANS-30.3-2022, Light Water Reactor Risk-Informed, Performance-Based Design, has just been issued by the American Nuclear Society. Approved by the American National Standards Institute (ANSI) on July 21, 2022, the standard provides requirements for the incorporation of risk-informed, performance-based (RIPB) principles and methods into the nuclear safety design of commercial light water reactors. The process described in this standard establishes a minimum set of process requirements the designer must follow in order to meet the intent of this standard and appropriately combine deterministic, probabilistic, and performance-based methods during design development.

Westinghouse's eVinci microreactor (Image: Westinghouse)

Westinghouse Electric Company has signed a service agreement with the Canadian Nuclear Safety Commission (CNSC) to bring the eVinci microreactor closer to commercialization, the company announced Tuesday. The agreement initiates a vendor design review (VDR)—a prelicensing technical assessment of a company’s reactor technology.

The objective of a VDR, according to the CNSC, is to verify the acceptability of a nuclear power plant design with respect to Canadian nuclear regulatory requirements and expectations, as well as Canadian codes and standards. The review also aims to identify fundamental barriers to licensing a new design in Canada and to assure that a resolution path exists for any design issues identified.

The International Atomic Energy Agency, for the second successive year, has revised upward its annual projections of nuclear power’s potential growth over the coming decades as an electricity provider.

In the just-released 42nd edition of Energy, Electricity and Nuclear Power Estimates for the Period up to 2050, the IAEA has increased its high-case scenario for nuclear by 10 percent over last year’s report. (In 2021, the agency revised upward its annual projections for the first time since the 2011 Fukushima Daiichi accident.)

According to the high-case scenario, world nuclear generating capacity more than doubles to 873 GWe by 2050, compared with current levels of about 390 GWe—an addition of 81 GWe to last year’s projection. In the low-case scenario, generating capacity remains essentially flat.

Ontario Power Generation and Microsoft Canada have formed a partnership aimed at combatting climate change and driving sustainable growth across the province of Ontario, the Canadian utility announced this week.

Under the partnership, Microsoft will procure clean energy credits (CECs) sourced from OPG’s nuclear and hydro assets in Ontario on an hourly basis. (OPG’s nuclear assets include the four-unit Darlington plant and six-unit Pickering facility.) According to the announcement, this will enable Microsoft to advance toward its 100/100/0 by 2030 goal, which commits the software firm to powering its data centers globally with zero-carbon energy, 24/7.

ANS and ANSI have published the following new standard, which is available for purchase in the ANS Store:

ANSI/ANS-19.3.4-2022, The Determination of Thermal Energy Deposition Rates in Nuclear Reactors (revision of ANSI/ANS-19.3.4-2002 [R2017])

Unit 3 at the Doel nuclear power plant has become Belgium’s first reactor to be permanently shuttered, in keeping with that nation’s nuclear phaseout policy. The 1,006-MWe pressurized water reactor, which began commercial operation in October 1982, was removed from service last Friday at 9:31 p.m. (local time).

Belgium’s nuclear reactor fleet now consists of six operating units: Doel-1, -2, and -4 and Tihange-1, -2, and -3. Next on the retirement list is Tihange-2, scheduled to be shut down in February 2023.

Moving forward with its plan for small modular reactor deployment in Estonia, Fermi Energia has issued tenders to three SMR firms—GE Hitachi (GEH), NuScale Power, and Rolls-Royce, developers of the BWRX-300, NuScale Power Module, and Rolls-Royce SMR, respectively.

As part of its planning and regulatory activities to potentially build small modular reactors (SMRs) in currently nuclear-powerless Saskatchewan, Canadian utility SaskPower has selected the province’s Estevan and Elbow regions for further study. (In 2018, SaskPower joined the Canadian government, three other provinces, and four other Canadian utilities to participate in the development of A Call to Action: A Canadian Roadmap for Small Modular Reactors.)

Released this week in the lead-up to November’s COP27 event in Egypt is a report from the United Nations Economic Commission for Europe, Carbon Neutrality in the UNECE Region: Technology Interplay under the Carbon Neutrality Concept, which calls for maximizing the use of all low- and zero-carbon technologies—including nuclear technology—to achieve net-zero carbon emissions by 2050.

Termed by the UNECE a “roadmap to carbon neutrality for Europe, North America, and Central Asia,” the 60-page report finds that to attain the net-zero goal, investment in energy as a percentage of gross domestic product needs to grow from 1.24 percent in 2020 to 2.05 percent every year from 2025 until 2050—translating to between $44.8 trillion and $47.3 trillion by 2050, with any additional delay in taking action adding to that price tag.

Some eight months after the Nuclear Regulatory Commission denied Oklo Inc.’s license application to build and operate its Aurora microreactor in Idaho, the company has returned to the regulatory fray. On Wednesday, Oklo announced that it has submitted to the NRC a licensing project plan (LPP) outlining its proposed engagement to support future Aurora licensing activities.

As the largest ultra-low-carbon electricity source in the United States, nuclear energy is a vital pillar of the effort to mitigate climate change. Deployment of advanced nuclear reactor and fuel technologies has been identified as a unique challenge in the production of new nuclear power plants to help maintain and grow our nuclear generating capacity. The licensing of novel nuclear reactor technologies also continues to be a facet of the broader challenge of advanced reactor deployment. When it comes to non–light water reactors and Generation III+ light water reactors, such as the AP-1000 or EPR, deployment is “2X over budget and behind schedule.”¹ However, in the case of recent large Generation III+ light water reactors, licensing has not been the rate-limiting step in the reactor deployment timeline, nor has it had a first-order impact on cost. With that said, several significant advances have been made in the expedition of licensing. This article focuses on three areas where progress has been made since this grand challenge was formulated in 2017, with highlights of some examples where the American Nuclear Society has guided or supported this progress.

Clean energy technology firm Bloom Energy has announced plans to install a 240-kW electrolyzer at Xcel Energy’s Prairie Island plant in Red Wing, Minn., to demonstrate the benefits of producing hydrogen with nuclear power. (One of Xcel’s two nuclear plants, Prairie Island houses twin 550-MWe pressurized water reactors.)

Curtiss-Wright Corporation and small modular reactor developer X-energy have announced the signing of a preferred strategic supplier agreement to advance the design and deployment of the latter’s Xe-100 SMR.

Laufer

Developing a first-­of-­a-­kind reactor is a daunting endeavor. To be successful, advanced reactor designers need to achieve cost certainty by delivering a safe and affordable product at the promised cost. To meet this goal, Kairos Power structured its approach around four key strategies: 1) achieving technology certainty through a rapid iterative approach; 2) achieving construction certainty by demonstrating the ability to build it; 3) achieving licensing certainty by proving Kairos can license it; and 4) achieving supply chain certainty by vertically integrating critical capabilities. By mitigating risk in these four key areas, Kairos Power is confident that it will get true cost certainty for our future products.

The third prong in Kairos’s strategy—achieving licensing certainty—was a key driver in the decision to build the Hermes low-­power demonstration reactor, and it remains a major workstream as the company’s construction permit application (CPA) undergoes review by the U.S. Nuclear Regulatory Commission. Licensing a new nuclear technology is no small challenge, and there are multiple approaches companies can take. Here’s a look at how we at Kairos are approaching it.

Paragon Energy Solutions and Reuter-Stokes have signed a contract to design and manufacture neutron monitoring detectors for small modular reactor developer NuScale Power.

U.S. utility Constellation Energy has signed a memorandum of understanding with ULC-Energy, an Amsterdam-based nuclear development company, to support deployment of a fleet of Rolls-Royce small modular reactors in the Netherlands.

Advanced reactor developers are designing many new nuclear energy products, targeting commercial demonstration before 2030. These products aim to provide different products and grid services beyond what is provided by the first generations of commercial nuclear plants, namely, gigawatt-scale electricity production. These reactors are intended for deployment in many novel scenarios, including being closer to population centers. They will be sited in governmental processes that encourage far more public participation than was possible when many of the existing plants were sited and built in the 1960s and 1970s. This means that community engagement and approval likely will be critical for project success. This article, which discusses this issue of social license, is an adaptation of “Social license in the deployment of advanced nuclear technology,” published in Energies in 2021.¹ A more detailed discussion can be found in the original article.

The International Atomic Energy Agency’s board of governors has adopted a resolution calling for an immediate end to the Russian occupation of Ukraine’s Zaporizhzhia nuclear power plant. According to a report from Reuters, the 35-member board voted 26–2 yesterday in favor of the resolution, with seven abstentions. The two “no” votes were cast, unsurprisingly, by Russia and China, while abstentions came from Burundi, Egypt, India, Pakistan, Senegal, South Africa, and Vietnam.

Portland, Ore.–based NuScale Power and KGHM Polska Miedź S.A. have signed the first task order and a statement of commencement to begin work under an agreement signed in February to initiate deployment in Poland of NuScale’s small modular reactor technology, the American firm announced this week. The task order was inked September 7 at the 31st Economic Forum, held September 6–8 in Karpacz, Poland.

The Nuclear Regulatory Commission is increasing its oversight of the Waterford Steam Electric Station’s Unit 3 reactor due to a decade-long miscalibration of a radiation monitor.

In a September 13 letter to Entergy Operations, the NRC classified the issue at the Killona, La., facility as a “white finding”—agency parlance for a problem of low to moderate safety significance. (The NRC’s Reactor Oversight Process uses color-coded inspection findings and indicators to measure plant performance, starting at green and increasing to white, yellow, and red, commensurate with the safety significance of the issues involved.)