ANS is committed to advancing, fostering, and promoting the development and application of nuclear sciences and technologies to benefit society.
Explore the many uses for nuclear science and its impact on energy, the environment, healthcare, food, and more.
Division Spotlight
Robotics & Remote Systems
The Mission of the Robotics and Remote Systems Division is to promote the development and application of immersive simulation, robotics, and remote systems for hazardous environments for the purpose of reducing hazardous exposure to individuals, reducing environmental hazards and reducing the cost of performing work.
Meeting Spotlight
ANS Student Conference 2025
April 3–5, 2025
Albuquerque, NM|The University of New Mexico
Standards Program
The Standards Committee is responsible for the development and maintenance of voluntary consensus standards that address the design, analysis, and operation of components, systems, and facilities related to the application of nuclear science and technology. Find out What’s New, check out the Standards Store, or Get Involved today!
Latest Magazine Issues
Apr 2025
Jan 2025
Latest Journal Issues
Nuclear Science and Engineering
May 2025
Nuclear Technology
April 2025
Fusion Science and Technology
Latest News
General Kenneth Nichols and the Manhattan Project
Nichols
The Oak Ridger has published the latest in a series of articles about General Kenneth D. Nichols, the Manhattan Project, and the 1954 Atomic Energy Act. The series has been produced by Nichols’ grandniece Barbara Rogers Scollin and Oak Ridge (Tenn.) city historian David Ray Smith. Gen. Nichols (1907–2000) was the district engineer for the Manhattan Engineer District during the Manhattan Project.
As Smith and Scollin explain, Nichols “had supervision of the research and development connected with, and the design, construction, and operation of, all plants required to produce plutonium-239 and uranium-235, including the construction of the towns of Oak Ridge, Tennessee, and Richland, Washington. The responsibility of his position was massive as he oversaw a workforce of both military and civilian personnel of approximately 125,000; his Oak Ridge office became the center of the wartime atomic energy’s activities.”
Philip J. Jensen, Nicholas Klymyshyn, Steven B. Ross (PNNL), David Garrido (ENSA)
Proceedings | 16th International High-Level Radioactive Waste Management Conference (IHLRWM 2017) | Charlotte, NC, April 9-13, 2017 | Pages 84-89
Equipos Nucleares, S.A. (ENSA) and the US Department of Energy (DOE) are preparing a full scale Spent Nuclear Fuel (SNF) transportation test. This transportation testing will include road, rail, coastal, and trans-Atlantic shipments. The test campaign will use a full scale commercial dual-purpose package and cradle. The package will be loaded with at least two instrumented fuel assemblies to measure strains at cladding locations and accelerations on the fuel assemblies, and “dummy” assemblies in the remaining basket locations. This testing is designed to closely match an actual SNF shipment. Accelerometers will also be used at various locations throughout the full conveyance system (i.e. rail car/truck, cask, transport cradle, and basket) to study the transmission of loads through the system and to provide validation for numerical models. Previous testing and modeling work has shown how the structural transmissibility of the transport system can affect the magnitude of these loads, and the importance of modeling all aspects of the transport system (i.e., rail car/truck, transport cradle, cask, basket, and fuel) (Ref 1, 2). This paper describes preliminary models that were constructed to estimate load transmission during rail transport, from the bottom of the cradle to an individual fuel rod within the package. The modeling studies in this paper evaluate the system response to postulated shock pulses and random vibration loads. These models describe the transmissibility of the conveyance, and demonstrate how loads can be amplified or attenuated as they are transmitted through the structure. This is done by coupling the rail vehicle dynamics code NUCARS, to the general finite element modeling code ANSYS, and the explicit dynamics code LS-DYNA. Models such as the ones presented herein will be used during the test campaign to help analyze and evaluate the test data as it is collected.